@9mmepiphany Pneumonia so bad it put you in the hospital is darn scary. Glad to hear you are doing better... the whole struggling to breathe thing...
Yup, I do wet tumble, but I can chuck them in the wiggler for a few minutes after they come out of the dryer to put a bit of polish on 'em. At...
Well, that did it. I adjusted the powder-through-expander die to put just a bit more of a bell on the case, and I can now take a piece of brass...
DAA uses that particular M Die to go along with their bullet setting die. Both are a matched pair, for .3555 diameter bullets. Using a .357...
SWC's can be troublesome to get to run well in 9mm semi autos. If possible, you'll want to get a few samples and try them out before buying in...
I have a huge assortment of expander dies... My last "pet bullet" required NOE's .360/.357 expander in order to keep from swaging down the bullet...
That's extremely helpful, thank you! I can imagine that if it's setting the bullet into the case hard enough that it won't fall out when it's...
This one. They're sized to .357 after powder coating. I really should take a look at that Hornady die... OK, so first off, that's the smoothest...
I'll mess around with it some more, but I currently have it setup to exactly match the picture shown on the installation instructions as far as...
Yup, but thanks for checking. :) The Mini Mr Bullet Feeder comes with an M die powder-through-expander funnel.
I probably wasn't clear in the OP... I've actually had the shell plate calmed down enough so that it isn't tossing powder out of the case for...
When I first got my 1050 four years ago, I was having powder spilling problems on a 9mm load, and was able to get the shell plate jump under...
I should've noted that this was for a Dillon 1050 press, @RodII. Edited the OP to add that.
Over the years, there have been quite a few threads/posts about guys having problems with Dillon shell plates jumping during advancement. This...
@jmorris I was just curious as to what your opinion is on the Level 10 Innovations shell plate stabilizer? You know, for those of us that aren't...
It's pretty rare that products live up to their hype. This was a happy exception... I think you'll be very pleased if you decide to get one.
I had completely forgotten about GSI's bullet feeders. I got distracted by the "Honey Do" list yesterday, so I didn't place the order for the MBF...
My son and I load a lot of 9mm. Multiple thousands each week. We've been hemming and hawing about getting a Mr. Bullet Feeder for years now, but...
A few more APP videos... Man, I can't wait to get mine. I'm so far behind on bullet sizing, it's going to take me forever to get caught up. The...
That distance is supposed to be adjustable... At least, I thought I read somewhere that it was supposed to be. Any luck on this since you posted?...
Separate names with a comma.
