Was bored picking up some range brass today and sorting tonight. After just dawn and water wash in the sink it is easy to spot norma cases. The...
Recently picked up the above. Most is lc and I believe it's most 69. There is one DEN 43 and a few fa match 60 and a few tw 52 and 53. One of...
Anyone have an ecopy they can post or send me. I see it on extremes site but my tablet won't download it.
Long story short have a lot of 5744 and almost out of h4895. I want a reduced load for 8mm, 30-06, 6.5x55, 45-70 and maybe others using common...
Put a new trigger in my 1895 today. Before the weight was a good 6+ lbs and now after the trigger and reduced hammer spring it is around 3....
Just curious. Have maybe 50 of these rounds. I pulled one and the bullet weighted 197 and the powder 43.3. Does anyone have an idea of what...
In the last week or so it seems like midwayusa got rid of it's ammo cost per round on the page showing all ammo. It used to have cost per round...
Got out my old mark I yesterday and I am getting around 1 ftf with fed automatch per mag. Shot more than half the box already with my sp101 and...
Looking to mount a mrd on my 357 1894. I can find the full picatanny rail but I am just looking for just a mount like this. Egw has this and it...
Anyone have any good suggestions for the above. Been carrying the little guy for while now loaded with 3 snake shot and 2 wadcutters. Now...
As anyone seen this. Winspp used in loading 9mm back in 2017. The primer i am showing in pic I tried to fire in a ppq 3 times and the Stryker...
Few questions on this little guy. Looks like the integral firing pin is broken off the hammer. I see numrich shows one. Looks like the cylinder...
Looks like end of era. I might have missed this. I got card in mail first of June saying this. I have been a subscriber for 30 plus years I bet...
Lgs has one for 497 plus uncle Sam. Seems like lately I have a hankering for a short barrel little revolver. Would use for car carry and maybe...
Tested my shot shells today in 1911 and g36. Loaded with 5.8 hp38 and #12 shot. At 7' definitely what I was hoping for. Both guns partially...
Got me a tx22 competition slide for my tx22. Question on mounting a mrd. Got vortex venom and a Burris ffiii. The manual for slide says use...
Found the below brass today along with one with a light primer strike round. The rounds have kind of a copper color to them and the primer has a...
Got the above. Fun to shoot inside and halfway accurate. I noticed I can pull the little barrel out the back of the gun. This probably effects...
Have the above and was curios on if I need to tamp bullet down or not. I just got using 5744 and had a couple no fires. Do I need to tamp the...
Ordered a replacement decapping rod for my 223 die. The new one is knurled. I never had an issue with the older Lee smooth rods so wonder why...
Separate names with a comma.
