Exactly. However, in general I find that I can use the full magnification of a scope maxing out in the 8-9x range at any distances where you'd...
I got Ruger's email and it said "temporarily discontinued." I interpreted this to mean "all our machinery is working on semiautos for the coming...
Carrying a rifle for any reason other than hunting will get old fast. Most people don't encounter a grizzly or have any bear issues. You should...
All of the name-brand JHP loads in the 110-125gr range are likely to be effective for your purpose. I would specifically look at the Hornady...
For your purposes I think a linear compensator would be worthwhile. I've used the Kies Blast Master, which I believe is gone from the market, and...
Look up "filthy 14" already mentioned above. With regular oiling you don't actually NEED to clean. I tend to clean every couple of range visits,...
Additional tip to OP: if you're going to rely on a ballistic turret or reticle, it's a good idea to zero at the longest distance you're likely to...
Good point, but note that Sierra provides G1 BC numbers over various speed ranges in their published detailed bullet chart. This helps you figure...
natman - yeah, that also seems plausible. B&C did claim this was a known issue though. I don't know.
1:9 - most commercial ARs until recently. Works fine with bullets up to 68-69gr BTHP. Some people report good results with Hornady 75gr as well,...
Smith Enterprise used to have a video showing a full-auto M14 being fired with their brake attached. It had no muzzle rise and looked perfectly...
Strongly agree. I would go with .308 to get the shorter action and slightly lower priced ammo (sometimes, at least).
I've owned both and both are fine. I have a slight preference to hinged floorplate because there's nothing to lose and nothing sticking out....
Most rust issues I have encountered involve guns stored in cases with foam lining. The foam holds moisture and holds it against the gun's metal...
Choate advertises that these stocks take paint well. Having painted three of them, I can attest to that. No paint you should consider using is...
For the left side logo area, you could potentially sand out just the lettering with a Dremel or similar. Or you could try using Bondo or similar...
It wasn't possible to insert both action screws - there was a mismatch in spacing between the holes on the receiver and the holes in the stock....
.308 ammo is also less expensive at a given quality/performance level, despite using more metal. And there is no milsurp 6.5 or 6.8 that I know...
Thanks. The claim of inch/metric difference was told me by a CS rep of Bell & Carlson when I asked why their Vanguard short-action stock didn't...
Yes you should, as others have noted. The trigger design is flawed and there's no way to know if yours will some day fire when you didn't pull...
Separate names with a comma.
