I have a stainless 1:9" PSA upper that shoots the ADI 69gr Sierra SMK ammo into tiny groups.
I couldn't ask for better performance at $12.99/20...
Mill dovetails in two cuts. The first cut is done with a standard endmill and takes out most of the material. The second cut just takes out the...
The guys at the Savage forum highly suggest you float the tang. I'd open up the stock to accommodate it.
The AAC SDN-6 is one of the best choices.
I didn't practice, I just went for it. There are some refinements I'll make next time. I did this with rattle cans. An airbrush would be way better.
I did this, using this method.
I started with a tan base coat, then added a brown fade. Then I applied stencils, trying to preserve...
It doesn't bother me at all. My M&P9 is utterly reliable and accurate.
I filled the forearm of a Savage synthetic. I used a burr in a dremel to "tooth" the channel, then brushed on a coat of contact cement as a...
Well dang. I was looking forward to hearing how nice that set-up is.
PA should take care of you, but busted kit always puts a damper on range time.
I always remove the extractor (and ejector in your case) if possible.
I want to "feel" the lugs seating. ymmv.
I've discovered my PA Micro still turned on… a few times.
That is necessary for the barrel to lock up properly into the bushing (machined) or pressed into the slide.
I'm confused. You broke your earpro, and stayed at the range? And you self diagnosed your injuries? And came here to rant?
Shootingthebreeze, you're either naive, or willfully ignorant of the motives of the groups you support.
Legislating the law-abiding isn't the...
I'm also pro-hot range.
A light coat of oil, inside and out, stored in a locked cabinet. Don't store guns in soft/hard cases where they touch foam or lining.
I'd shorten the barrel to 16"
You gain very little, if anything, from the extra inches.
I did this. Feels good. It took me 20 minutes with the soldering iron.
Uploaded from my phone, sorry if it's huge.
AIM was selling steel .223 for $110/500 before Sandy Hook.
This entire thread could have taken place in the Muppet Show balcony.
Separate names with a comma.