I am using LC military brass... is it safe to go to 26.5 g with military brass?
Defensory sez: But I believe that issue was already addressed when Fiddletown stated:
Barrel break in is a myth. Shoot. Clean when needed. Repeat.
and therefore activate the slide stop before the magazine is empt? Where does the magazine follower make contact with the slide stop? I have...
Somewhere between 3 pounds and 10 pounds.
You did it intentionally after another poster just described that he couldn't get it disassembled afterwards? No offense, but what you were you...
Ok, the reason I was looking at the G3 was because I wanted a semi-auto 20 gauge that could shoot 3"shells and I liked the 1100 already and had a...
I don't think we are comparing the same guns. I am comparing a 20 gauge 1100 G3 (which is what I am leaning towards) to a 12 gauge Beretta 391...
How many #4 shot pellets are in a 3" 20 gauge shell compared to a 2 3/4" 12 gauge shell?
I don't want to have the barrel threaded for chokes. My 1100 is pretty old, and I do not believe Remington still makes replacement barrels for...
I am looking at Remington 1100s. I have an old (~1976) Remington 1100 20 gauge that I have been shooting since I was 12. So after about 25...
The main reason I would prefer a 20 gauge is because most of my shotgun experience has been with a Remington 1100 20 gauge that I have been...
So that should work ok for Turkey then ?
I am looking to buy a new shotgun, and am thinking about the Remington 1100 G3. This can handle both 2 3/4" shells and 3" shells. I am leaning...
I have two Beretta Stampedes, and they shoot better than my Colt Single Action Armies.
I think that is a bad way to fix this problem. The problem is too much metal on the slide stop, and it seems to me the correct fix would be to...
I am sorry you had a bad experience with your gun, but why did you pay so much for it? They are routinely being sold for $200 less than that.
What would be best to use, a small hand file or a Dremel? I am kind of afraid of using a Dremel, it can take off a lot of metal in a hurry
I have a Kimber 10mm Eclipse. The factory slide stop was unusable, and caused the slide to lock back after every couple of shots. I replaced...
I am not sure I understand why that is illegal. If someone really believes a zombie rising is imminent, then it would seem reasonable to me to...
Separate names with a comma.
