I put together this pistol rack to fit in my safe out of some scraps of 1/2" plywood lap siding, 3/4 aluminum angle, and some peel and stick...
yep, just adding a few lines of G-code to the program to break the sharp edge is all that's needed. A close look at the profile of other brand "M"...
Test run of small tumbler today. [ATTACH] I was looking for a tumbler smaller than my FART to do smaller batches to keep all cases in the process...
yep, and fix is a hose clamp: [ATTACH] What I did... Sorry for the echo Hooda Thunkit. .
After many knife sharpenings, I have determined I never shave with a knife I have sharpened and don't need that type of edge, ever. I use an old...
I think Lee sells sizers in 0.356/0.357/0.358 diameter, and I push all coated bullets thru the 0.358 die to qualify them and size them again...
I buy coated bullets in the biggest diameter available and push them thru a $20 Lee sizing die for whatever gun I am going to shoot them thru. I...
The info you are looking for is in this post:...
At Lowes: Gardner Bender 3/4-in Drive Torque Wrench in the Torque Wrenches department at Lowes.com sorry if this is an echo.
I use a lot of T-nuts too, usually from the bottom up/underneath though. That way the underneath flange allows more torque on the bolt screwed...
OK, I just posted this in another thread yesterday: Just something I do, that I have found stops crimped primers from getting stuck on the pin...
Just something I do, that I have found stops crimped primers from getting stuck on the pin and sucked back into the primer pocket. I put the...
Thanks for the update. .
The tumbler needs to be on concrete (floor) or on a block of foam for the box over trick to work the best. That metal cabinet becomes a speaker...
That movie plays often on the A&EHD channel on cable, along with a lot of other shoot'em-up//car chase movies. No cable? nevermind, .
That notch may be the weakest part of the cylinder and underlying chamber. If overly pressured ammo was shot that area may have bulged out into...
I just drop an upside-down empty cardboard box over the tumbler when I'm working near it, that and it's on the concrete floor, on a rug. just me...
Yes, so many double stack (and single stack) Glock CLONES out there with way better ergonomics, even with interchangeable grip panels for a custom...
I gave the torque specs. way back in post #14 "Torque spec. is 5 PBIS": 5 pounds before it snaps. 5 pounds before it strips. 5 pounds before it...
yea sure, except they used the wrong end on that 1/2" combination wrench, should have used the box end. jmo, .
Separate names with a comma.
