It is not going to be cheap.... Unless you are willing to have A LOT of them made.
Are you trimming your brass to the exact same (less than maximum) length everytime before reloading?I
Entire case is being squished by overcrimping.
Squished case not chambering, squishing case even worse.
Trim to minimum case lenght, then seat...
Hawaiian Shirt, in long/tall.
Yep, the same Corps that didn't send Marines to the early Pacific theatre with M1s, but M1903s instead.
I found the stamped .22 ejector to be the "Jesus Nut" on Ace 1911 conversions.
Removing the stock 45 ejector, especially if it is oversized has...
Id say your overcrimping is causing the problem and chambering is making it worse.
Try trimming brass to minimum, and seat the bullet without a...
Gambling requires "luck".
It's all skill if I'm gonna put money down.
Radway Green, MEN, Aussie F4, Hirt, DAG
Basically from any country where you could drink the water and have a NATO cross and circle headstamp....
Everybody needs to go to the SAR Show at least once.
But I enjoyed buying a cheap switchblade in Mexico as a teenager.
Which one is a better swimmer?
"30-06 Based Cartridges"
7mm x 57mm Mauser.
Errr... The other way around.
So 7mm-08 I guess.
I could never get over their initial offering.
And don't forget about eye protection also.
Saddle soap, followed by paste wax.
No petroleum products!
Real men use radians :eek:
Using 19.5" wide for the " E" type target, I get 28 yards, or 25.6 meters
X= distance wanted in inches
20/x = m9 target width in inches/984.25
Separate names with a comma.