My trimmer trims off of shoulder measurement. If it needs it, it trims it. The bullets I use have a cannelure. I crimp slightly into it.
Any updates on progress of this?
I also use a similar light to this. Put a large washer on my bench top, next to press, with silicone. Magnetic light base sticks to it.
I guess a person can't turn the primer pockets inside out like underwear. :rofl:
Loaded up 100 9mm.
Another item I picked up for the FART was a pair of screens. I open one end and replace the clear piece with a screen. Turn it over and as the...
I also use a media separator that's filled with enough water so brass will tumble in it to separate pins. When done, I remove the pins from the...
My full size FART doesn't have a handle on the lid like the lite version that is pictured. Sure would make it easier to carry to the sink.
If it's the large rotory tumbler, they claim it will do 1000 .223. I've done 500 with no problem. I use a cap full of armorall wash and wax in...
Loaded up 185 rounds of .223.
I'm sure if you post it in the for sale section, you would be able to sell it.
Thanks for the offer but I'm not sure which route I will go. I mark my own brass so that I know it wont need the pocket reamed again.
Thanks for the responses. A lot to think about.
I have been reaming a lot of .223/5.56 primer pockets lately. Just wanted some feed back from those who have used the Hornady lnl swage kit. Is it...
Wet tumbled 400+ .223/5.56 brass. It's in the brass dryer now.
I started with Lee equipment and still use it today. Did add a Hornady lnl ap, but its red as well.
I'm following this thread. I am getting the same soot covering with max load of western powders Zip.
Sorted through a couple gallons of range pick-up.
I started sorting through 2 gallons of range brass I picked up yesterday. A lot of .223/5.56 and 9mm was on the ground.
Most super markets have it. It is a dishwasher additive. Also can get it on amazon.
Separate names with a comma.