I did not buy the stand because I use the Inline Fabrication quick change system. I have a four inch overhang on by bench, and the top is 1-¾...
I'm sold on Imperial Sizing Wax. Just keep a dab of ISW on your fingertips as you feed the brass into the press and you're all set. That "spray"...
Funny you should ask. I just unboxed my new Marksman and I am mightily impressed. It is solidly built, not too big but pretty heavy, and the...
I'd have to say the LabRadar chronograph. It's not cheap, but this machine has completely spoiled me in a number of ways. First, it's very...
Check the tube. There may be four squibs stuck up in there.
For me it wasn't a piece of equipment but a discovery: that the majority of problems with presses can be attributed to a single system, the...
I've discovered a little tactic that takes the sting out of paying Cabela's prices: their gift cards are sometimes available on EBay for 80¢ on...
I bought my last two cases of 9mm for 14¢ per round after rebates and free shipping. One case was Federal American Eagle 115 gr, the other was WWB...
Reloading bottleneck rifle cases on a progressive press can be done, but it requires some additional thought and some minor adjustments to the...
This has been an excellent give-and-take on a somewhat frustrating situation: we all know exactly what we mean, but find that there isn't a single...
There are only about six answers here that are responsive to the question asked: Hot, Unsafe (or Not Safe), Ready, Charged, Unknown, and Not...
I am re-writing the rules for our gun club, and need some help. Specifically, I need a term for a firearm that is not demonstrably and visibly...
Thank you for that!
I just got the firmware update and the app. Everything is working as advertised. For those having problems pairing the app and the LabRadar: you...
Don't get a whole new set of dies...just get additional seating dies. I have two or three seaters for ever caliber I reload. I number them with a...
I shoot revolver matches at 70 yards using cast bullets in .44 Mag and find that trimming cases gives me a much more consistent roll crimp and...
I dump them on a big cotton bath towel, gather up the four corners, and toss them around for a few seconds. That dries the outsides and empties...
I had assumed the opposite: that the grooved bullets, being a tad longer for the same profile and weight, might be more accurate. The same effect...
I'm extremely happy with the RCBS lockout die. The instructions are a little obtuse, but there's really only one adjustment possible, and after a...
I think it's important to remind new reloaders that with semi-wadcutters the portion of the bullet forward of the shoulder is just hanging there...
Separate names with a comma.
