I see "Factory Seconds" advertised here and there. I assume most often these are bullets, but are other components also advertised that way and...
This is the kind of stuff that makes this forum priceless. Hundreds of years of knowledge and experience available for every obscure problem that...
Did a batch today and spread them out in a single layer of a baking sheet that was too big to fit into the oven. Simply allowed them to air dry....
I have learned that military brass has a crimped primer which changes the depriming process some. I have found advertised a Dillon Super Decapper...
Yes, rinsing until the water is clear. This time, I was away when the tumbler stopped, so the cases sat in nasty water for a while. I set the...
I am depriming with a Harvey Deprimer. You feel the pin sink into each flash hole. I have run across a few that I could not find, and upon...
Just did my second batch, the first without the blue goo that came with it. I used a 9mm case of lemishine and a splash of car wash detergent....
I have picked up a lot of .223 range brass lately. I set about depriming it only to find that it is VERY hard to deprime. I broke a pin doing...
I don't have a press or any dies, but I sure have a lot of nice shiny brass! By the time I get some equipment, I'll have a trash can or 2 filled...
Just got one (delivered on Sunday!) and have it tumbling it's first batch. Everything I read leading up to this purchase indicated that people...
I just bought a Harvey Deprimer. It might be the slickest gadget I've ever seen. I have been collecting range brass, every caliber you can think...
At this moment there have been 44 people to respond, totaling 1399 years! Thank you all for playing along. Iggy has logged 65 years and Papa G...
Good spot! Picked up another decade just like that!
First FOUR guys, 146 years. That's nearly as old as I feel!
First 3 guys, 98 years!
With all of the experience represented by the members of this board, I'll bet that coming up with a millenium of reloading history would be an...
Newby, here. Looking to get into this craft and am delighted to have found this forum. So much knowledge here. The first thing any new guy has...
I found a round bearing this mark while sorting some range brass and had never heard of such a caliber, so I looked it up. I'm seeing info on...
I have seen scattered suggestions to buy this or that from Harbor Freight and I wonder what serious reloaders think about that. Calipers, scales,...
Since this is a craft that involves incredible precision, I am sure many of you will use a lighted magnifying lamp of some sort. There are many...
Separate names with a comma.
