I do the same thing, with a few exceptions. We have had unusually cold weather and snow here and I've stayed in. But usually about this time of...
I use mostly MTM plastic boxes. But you can end up with a substantial investment pretty quickly. The repackage boxes that I have seen look to be...
I have used several different hand priming tools, some of them quite expensive. But I've never been disappointed with the results of priming on my...
Their customer service has always been legendary. Its good to hear that they are still that way. I wish they would bring back whatever parts of...
I guess everyone has a wish list including me. There are a few still on mine. 1. A S&W M-27 with the 3-1/2 barrel, blued, pinned & recessed. 2. A...
I have both. The Ruger is no doubt the stronger of the two. Mine has a half-way decent trigger. The S&W has the better fit and finish and the...
I put Leupold VX-111 1.5-5's on mine and my Wife's 22's. It a fairly expensive scope for an off the shelf 22 rifle but I expected them to be...
I can think of a couple that I bought that were priced a few hundred dollars under the going price and that I expected to have to work on. 1. A...
Thats a remarkable accomplishment. Welcome to "The Brotherhood". I saw where someone suggested taking pictures and recording serial numbers and...
Being the kind of guy that I am, laid back and low profile, I voted to leave it plain. But I see the humor in it! :)
I uniform all of mine. I have one of the Whitetail tools for large rifle and use a Sinclair tool for small rifle.
I'm seeing less shooting around here. My buddies that reload were pretty well stocked and continue to shoot about like they did, pre Covid. Those...
Good on you for helping a fellow reloader out. And a stranger at that!
Thats true! The older weights that I have had tested had about .5% to 1% more tin than the newer ones do. Test of clip-on weights that I have had...
I have the larger Dillon that works well but its kind of pricy. But for years I used a plastic tub and a French Fry basket.
223 is leading the pack for me right now. I have a new build in the works chambered in 308 that will probably elevate the 308 up to 2nd place. I...
The posters above pretty much covered it. The nickel plated brass should not hurt your dies but if a piece of nickel flakes off and sticks in a...
A cheap set of steel stamps from Harbor Freight makes a permanent mark. I use "WW" for clip on weights, PB for soft lead, ect. I bought 2 sets and...
I like and recommend the Lyman with Sierra being next. But like most of you here, I have several. I think dgod has me beat though!
I do my best to buy "Made in the USA" no matter what the economy or political situation is. Its hard to do at times.
Separate names with a comma.
