GM sold their mail order business to Cabela's or Bass Pro years (around 15) ago. Not every state has a GM. They were doing OK for gun prices,...
If you'd like more indepth iformation concerning the CZs, check out RFC.
The Starlight 352 does have a couple inches in length over comparable Pelican and Hardigg cases but the new Pelican 1770 seems to be the top dog...
Just before Pelican and Hardigg (maker of the Storm) merged, Pelican revised their latches to be less knuckle busting. It is a two part latch with...
Absolutely big and bulky and cumbersome and require more work and attention to transport. I have to drop the rear seats of my car to fit a...
Yoda,, I do not understand. Why did you not use The Force?
I wonder how hot the charging handle gets under sustained rapid fire.
11mm is measured at the top of the grooves. 3/8" is measured at the bottom. If you were to measure the 3/8" groove at the top, it would be close...
soylant green?
I received mine about a couple months ago. About a year after ordering it (11/07).
Sounds like the Wildcat has the regular European 11 mm grooves.
If you decide on the Ruger 10/22M good luck on your search. They are a rarity now and the prices being tossed around are in the $600-$1000 range....
I'll bet the groove on top of the receiver is 13mm and the bi-pod can clamp into the (recessed) rail under the forearm (as I'm sure you're aware).
Folks not into position shooting wouldn't really care for such a free rifle and there are many here that are not into that discipline. Another...
Are you sure it wasn't the phenomenon of shooting match grade ammo first which leaves good coating of the paraffinic coating (on the bullet) in...
The question refers back to the post above it by eye5600 requesting additional information to the poster's reply, I've never seen a gas op...
I don't think I've ever seen simples blowbacks that use small caliber relatively low pressure pistol rounds (e.g,, .22 lr, .25ACP, .32 ACP, .380...
You may have to back to get those MiniMags. The Mosquito may take a little bit of breaking in with the hotter stuff to settle in. A couple 100...
Depends. Certainly, taking a tube and grinding or cutting furrows into it will weaken the structure. That is, start with the finished OD, cut...
Can find the video, but you mean something like this? [ATTACH]
Separate names with a comma.
