So you are calling BS on me? What a moron. Yup my motivation was to keep all the primers for myself or maybe **** on your parade. I was...
I hope you all well in this endeavor. I did not write the below directing this towards any member, seller etc but just recounting past...
I ordered a SDB Quick Change kit and cal conversion Monday and it shipped already.
Buy both a SDB caliber conversion kit and a SDB quick change kit is $297.47 delivered.
You do realize $389 is a heck of a deal.
Normally I rep and reload. If I'm not going to reload within a few days I store them in something air tight so they don't tarnish. It very well...
If we are talking about prepped brass then a ziplock bags. If its not prepped then a 5 gal bucket.
I've never cleaned it. If the clear plastic hopper gets dusty I use windex or alcohol. If you are asking about a new hopper I rub them down with...
Do yourself a favor and look at the Hornady collet bullet puller. The RCBS is good but the Hornady is easier to work with. I have the RCBS.
You did not mention how many grain bullets you are loading. Check the Hodgdon load data as you seem to be under the starting load for their listed...
In addition to all the good suggestion above... I clean and lube every 3-5k or when I change to a new caliber. My machine sits idle during the...
I enjoy the recoil pulse of medium to heavy bullets with fast powder.
I don't know how it happened but my handgun dies are RCBS and Dillon and rifle are Redding, Fosters and a few Dillon. On every cal I crimp I use a...
There are big variations in the length of the projectiles. Measure for yourself loose projectiles and see the amount of variation. You are far...
I have 30-06 surplus with 4 section and 8 section crimp marks. ETA And I've shot a few k of it over the years without issue.
I'm using 4.2 tg @ 1.10 to function all 9 of my 9mm.
For bulk rounds I use Little Crow WFT or Dillon rt1200 and for smaller runs I use RCBS Trim Pro 2. I recently purchased the Lyman case prep...
I finally went from handheld and drill driver case prep tools to table top. My hands just can't take the positions to use the handheld and drill...
I'd do absolutely nothing unless he was on the 10 items or less line at checkout.
Did you chamfer? Have you sized the bullets?
Separate names with a comma.
