IMO, if you are having difficulty sizing 9mm using Hornady dies on a LNL press, then something else is happening. I have an older Hornady...
Hornady Critical Duty......look at the research. Bullet weights are heavy and penetration/weight retention is excellent.
IMO, for pistol it's hard to beat Universal Clays or 231 (HP-38).
On the firearms side: Smith and Wesson and Ruger
Reloading: Rocky Mountain Reloading and Hornady
5 gallon bucket full of sand. Secure piece of cloth over the top and blast away.
You save a lot of time charging all the cases at once. Also, in my opinion, it is easier to recognize an overcharged case when you have the other...
Yep, also just cup my hand around top of powder measure. Makes a good funnel.
I run both Extreme and Powerbond 115 grain plated bullets at mid-jacketed velocities and have great results.
Springfield XDS in 45acp.
I've bought a lot of brass from sellers on ar15.com
Horseman61, the desk will be yours whenever you want it. I'm in no hurry....it's been sitting around for 10+ years.
Horseman61, you have a PM
Will take measurements and pics tonight.
I think the challenge will be maintaining stability during resizing operations on a smaller portable table that would not be attached to a wall...
Yep, bullet profile is the important point to remember in this thread. I can tell you that, with most bullet profiles, I have to load to a...
Springfield XDS .45
As an owner of an HK45C, I'll add my two cents. Yes, it is expensive for a polymer gun. I own handguns from all of the major manufacturers and...
Year round...Springfield XDS in 45 ACP.
The Bullet Hole in Overland Park, KS has HP-38 and 231 in stock as they got a large shipment about 2 hrs ago.
As an additional suggestion, you might try the following to try to isolate the chamber(s) that are causing the problem. Fire one round a time and...
Separate names with a comma.