Search results for query: *

I think it’s bit of a derail but thats how threads go sometimes, they just evolve into something else. This one wasn’t about how tough Nightforce scopes are.

I wasn’t meaning to derail a thread, but this is the original question.

Yes we’ve seen that before , how well it worked is anyone’s guess but that’s not to say they’ll replace it free as does Vortex.

At $2000 each , I’m pretty careful not to abuse.

NF doesn’t warranty self inflicted as does Vortex, sure they’ll fix it but you may have to write a check for at least a part of the cost.

I found myself being a little more nonchalant knowing I had that warranty. Just me being honest, with a Nightforce I find that I’m always extra intent while handing the rifle.

Definitely unfortunate, but here’s a question for vortex owners; Are you less careful of accidents knowing you have that warranty or the same as if you had a super expensive scope without the blanket warranty ? Curious.

Yeah, might not be the best option but I’ve seen a lot of long range guys do it at my range, I have rigid leather bottom on my bags that sometimes sit directly on a concrete bench without the spacer and no issues, maybe fill rate and composition in the bag plays a bigger role? I know I adjust...

I’ve seen guys double up plywood to make a small square then add skate board like tape or sticky rubber mat. Myself I order spacer/ leveler bag to go under the rear bag.

Sounds like a good time, do they have live pits or e targets ? What course of fire is planned ?

Congratulations’ The best short range shooters in the world can’t do that on a consistent basis with highly specialized rifles. Everyone I’ve ever talked to has thought their cleaning routine was good until they got a bore scope and found out the truth. Including myself. It’s not the end of...

The press release is easy enough to read.

I understand what you’re trying to do. I can’t say it’s wrong either, I just don’t see where trimming an extra .005 or .010 is going to affect seating depth , necks are plenty long enough to jam .030 and still have the pressure ring deep in the neck yet above the neck shoulder junction. With the...

Miles city Mt.

I would agree with you and add that trimming .020 short of SAMMI minimum is plenty safe. I’ve bought new 308 brass that measured around 1.95

Ta Da !!!

I trim .015 short of the reamer print, I could set my trimmer to .020 under without issues. I’m not comfortable getting less than .010 clearance even though my cases do not grow very fast I still use caution.

No it doesn’t , but only a scope will tell you when the job is done.

You may find a Nightforce 12-42 at that price, you could certainly find a Sightron 10-50 x60 or Sightron 8-32 x56 all three are excellent and all are available in 1/8 clicks, the next step up at $1200 street price (2nd hand) would be Vortex Golden Eagle 15-60x52 .

I can’t speak for another man however a full push and pull back through is considered one pass. Caution at the muzzle to not be rough with the crown area.