Search results for query: *

Check out J&G sales.

I ordered the #10 Rem caps online for $3 a tin. When I got them I noticed the foil covering the primer stuff, they go bang fine but the dia. is bigger than the new #10's so they're loose on my nips.

Did the Rem tins say FC on them? If so, they are the older foil caps.

The Silx-shot nipples have two side blow holes in them that blows the the caps off pretty much every time. Don't have to pry the caps off. This is on my 44 Pietta.

The new slix-shot nipples with Rem #10 or #11 work great on a 58 Pietta. Seems like the #11's are a little shorter than the #10's. They're right at $40 shipped.

Anybody have a list of the BP revolver weights. Thanks. Pitch

Just received my new 450-200 mold today. time to try it out! Thanks for the advice.

Desidog. Some SS does have carbon it to make it harder.

X 2 on the Rem #10

I'm shooting a Pieta 44 and using Rem #10 or#11 caps with the Slixshot nips. Caps fit snug vs the stock nips and it has never jammed. A friend I shoot with has a Spanish 70's 44 and he's using the nips also with no problems.

I use the Treso swivaling handle and 44cal brush in hot soapy water to clean mine.

I loaded up my 44 58 Army with 45 grains, no wad, just ball. Slix Shot nips with snug fitting Rem #10 caps. it fired and knocked the next cylinder cap off. Chain fire big time!!!. I'll stick with 30 grains.

I got the caps today and the tins had a band on them, not like the ones at the store. I opened one tin up and looked at the inside of the cap and it did'nt look like there was any green powder in them! I thought OK, I better ckeck them out out. I loaded 3 in my 44 Rem with no powder, just the...

I forgot to mention I ordered them from 3rd Gen shooting Supply. I ordered them on Aug 27th and they said it may take several weeks becuase of the Haz-mat fee.

I ordered 1000 #11 Rem rifle caps from them and I got a shipping notice that they'll be here Wed. Works out to $6.50 per tin. I'll let you know if they are BP caps.

I bought a HF tumbler last year and it came with 5 extra belts. Do'nt run them too tight.

I want to ask the same question. What do you do with the cord for an electric heater? I have a Winchester 24 gun safe also?

Not sure of the BHN but it works in my 44 NMA using the loading lever with 454 round balls.

That's exactly what happened. I have been smoking the mould too. My lead temp is around 800*. No more lubing it up with beeswax too. I"ll leave the last ball in too. Thanks for the help guys!!

I'm not using any mold release agents. The lines are'nt at the parting line. I do use beeswax at the end of the casting session to coat everything. The pot temp is about 800*. I was looking for an easier way to clean the moulds faster. Thanks for the help so far. PS I might try the toothbrush...