Hello,
I also purchased some of this powder since my usual choices of TAC and H335 were out. I’ve been using 24.2 grs with a 55 fmjbt Fiocchi SRM and assorted military brass. It’s grouping pretty tight and equal in my opinion to 24.5 grs of TAC and 25 grs of H335. Does anyone else have any...
Hello,
I got a chance to buy some SRM (6000 to be exact) because my usual choice CCI SRM have been impossible to find a while ago. I’ve shot about 1000 of them now in my 3 AR’s and have been very pleased. No one FTF in the bunch. Anyone else have similar results or any thoughts? Thanks
Hello,
I just got a good deal on a few thousand win small pistol mag primers and would like to use them in 9mm and 40sw along with my 357 mag. I usually use WSF powder in both - 9mm load is 115 fmj with 5.5 grs and wsp. 40sw load is 6.3 grs with a 165 gr xtreme tc and a wsp. How much should...
Hello,
After some time off I’m getting back into shooting my pistols again. Ran out of Unique and had some CFE Pistol so I decided to try it. Really like 8.5 grs behind a 255 gr LRN. Anyone else have experience with or feedback on this combo. Is there a better one I’m unaware of.
Thank you in...
I was using 6.5 gr WSF in my glock 22 with a 165 gr bullet and doing well with it but then I tried 7.4 gr Hodgden Longshot and what a difference in velocity but less pressure and the accuracy was amazing. 5 shots inside 2 inches offhand at 25 ft. Has anybody else tried Longshot and had a good...
My friend just gave me 3 lbs of Green Dot and I have never used it before. Mostly I use BE, Unique and 231 in 45acp for 200 gr LSWC.
I am looking for a load that is very similar to the two loads I am currently using and really like which are 4 gr BE and/or 6 gr Unique. Thanks for your help...
I have just bought some lead 140 gr TC Missouri Bullets. I would like to reload these in my SW 610 revolver in 10mm. The only data I am finding is with Accurate #5 and #7. I have some Longshot and WSF which should work I believe since they are similar in burn rate. Can anybody help me with...
I just bought some 140 gr TC Missouri Bullets for my 40sw. The only load data I have found so far is with ramshot Zip & Accurate #2 and #5. I have WST, WSF, Longshot, and 231 on hand. I figure one of these has to be a good fit. Can anyone help point in the right direction with any of these...
Gentlemen,
I have been using Power Pistol in my 9mm, 40sw, 10mm and 45 acp pistols. It works well and has good velocities but also seems to have a lot of flash. I have noticed that others speak highly of Universal Clays and would like to know why. Could you tell me which you prefer and why...
Hello Gentlemen,
I just bought a CZ 75 SP-01 and am not sure if I can shoot lead bullets through it. I have a glock, sig sauer and baby eagle that all have polygonal barrels. Is this the same situation as those. Thanks in advance for your knowledge and wisdom. :confused:
I have some Power Pistol that I am use in my 10mm & 40 SW currently. I was wondering if it would be a good choice in 357 mag with a 158 LSWC Missouri Bullets (18 hardness) at magnum velocities. Is anyone else using this combo or should I stick w/ 2400 and Blue Dot? Thanks for all your...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.