Search results for query: *

thanks mike, yes the collet would move up with each resize stroke and i beleive i did them all equally, was also afraid of bulging case with too much down stroke.

new to rifle reloading, waiting on backorder for case headspace gauge for first .223 rounds i loaded as they are too tight in chamber. so i shot some factory ball ammo thru 2 new ars. these empties would then chamber and eject easily from either gun. i reloaded these using only the neck sizing...

my local wallmart never has anything in ammo, i hit acadamy at 8 am and dicks spt gds at 9am also cabelas when trip waranted for reloading supply attempt also at 9am , you have to get there when they open or get in line before they open. last fri i got there a couple mins to 8 at acadamy and i...

wish i had a range where my problem was picking up extra brass with wrong primer size, most ranges pay more attention to someone picking up brass than they do to safe gun handling.

thanks for info sizing die, touching plus 1/4 turn in will turn in further, did not have to beat on chg hndl just tap on dowel but thanks for butt stock tip. thanks for phillips 2 tip looked for reamer all backorder thanks, joe

first question, primer pockets winchester fired brass with what appears to be small ring completely or partially indented around fired primers. new primers will not enter primer pocket. are these crimped primers in winchester brass or is this caused by gun that fired them or what? ok, 2nd...

i'm new loader with a glock 40 reloading my used brass some on its 3rd reload, it always has a glock bulge. what's a bad bulge? Loading mostly light loads but put some fmjs together with some below max. unigue data and they seemed pretty hot. but my brass looked ok. primers looked ok. am i...

i have loaded both rainier and berry's plated. i use 10% below load data for jacketed and try to find data that matches bullet type hp rn fp etc. you can also use data for lead bullets if they match yours. I also got some fmj 180 grn hp from rose dist. those are zero brand bullets and cost is...

just did a search for zero bullets on this site with no luck. anyone have feedback? i shot 3 samples of 5 each. also have loaded and fired rainier and berry plated but would prefer zero jacketed. any recomendations? 40,45,38/357? thanks

thanks to everyone for the info. joe

38 spl. and 357 mag. , are all silver cases nickel? how do you tell? does it make any difference when reloading?

soeey, had to step out. thanks everyone for your input.

ok, but will the seating die and factory crimp die also work?

i see that 2 of the dies are stamped 38spl./357mag. can i use these to load 357s? if so do i need to purchase two additional dies or would i be better off just purchasing a 4 die carbide set for 357? new to the reloading game. thank you.