Search results for query: *

new to rifle reloading, waiting on backorder for case headspace gauge for first .223 rounds i loaded as they are too tight in chamber. so i shot some factory ball ammo thru 2 new ars. these empties would then chamber and eject easily from either gun. i reloaded these using only the neck sizing...

first question, primer pockets winchester fired brass with what appears to be small ring completely or partially indented around fired primers. new primers will not enter primer pocket. are these crimped primers in winchester brass or is this caused by gun that fired them or what? ok, 2nd...

just did a search for zero bullets on this site with no luck. anyone have feedback? i shot 3 samples of 5 each. also have loaded and fired rainier and berry plated but would prefer zero jacketed. any recomendations? 40,45,38/357? thanks

38 spl. and 357 mag. , are all silver cases nickel? how do you tell? does it make any difference when reloading?

i see that 2 of the dies are stamped 38spl./357mag. can i use these to load 357s? if so do i need to purchase two additional dies or would i be better off just purchasing a 4 die carbide set for 357? new to the reloading game. thank you.