Search results for query: *

I've been using 56.0 gr's IMR 4350 for Hornady's 165 gr Interlock and have no reason to change. I use that powder for 270,30/06,300 Win Mag and 300 Weatherby Mag. I have used Reloader 17 with good results but since IMR 4350 has been back on the market for the past few years I stick with that.

Fire Moose I use Wipe Out for copper in my rifle's. It foams up right away and wait several hours or over night and run a brush through and you will see more copper than you would think could be in that barrel. I have heard some say it's impossible to remove all copper but you can.If you have a...

I only use the kinetic hammer on pistol bullets these days. Forster is one of many bullet pullers you use your reloading vise with and just screw it in and pull bullets. For my peace of mind I resize the neck and use a Factory Crimp Die for a secure hold on the bullet.

Para-P12 45 acp with 185 gr Golden Sabres

LongRifle,how much does the fire control system cost?

I have grown fond of Wipe-Out.If there is a whole lot of copper I use the Wipe-Out Accelerator first then Wipe-Out spray foam.I set the rifle up on end with the muzzle facing up,I plug the chamber and spray the Wipe-Out in and let it soak for 30 min.Sometimes I let it soak over night if I have...

It sticks with factory ammo(68.00 per box) and reloads. I plan on doing as suggested and have the barrel setback and rechambered.Thanks for all your help.

I too have a 742 in 30/06,it works just fine. There is a gunsmith in Washington called Bear Creek Guns.Ray Gregg is the gunsmith and remington gave me his email address.If you want I can go find it and post it. He says the 742 in the original state will hurt itself if used enough.He machines a...

I forgot to add that my reloads shoot very well in a friends 300 H&H.

I have never loaded the rifle hot,I load slightly over 30/06 velocitys.I clean the rifle everytime I use it.The bore and chamber is spotless.

When I let it cool down I can extract the fired case. this is a rem 721 300 H&H.Extractor is fine.I can tear the case head off if I force it.A no-go guage will not close so head space should be ok.chamber looks shinny but without a bore scope I can't see it all.Thanks

What are some of the reasons shells stick in the reciever even with minimum loaded shells?

I own a rem 721 in 300 H&H.The shells stick in the chamber when shot even with minimum loaded shells. Awhile back I sent the bolt to a gunsmith in Selah Washington.He fits a 700 extractor in the bolt,the same ones the military uses.The extraction problem may be fixed but the shells still stick...