Search results for query: *

no the cases were not wipped before taking the photo, the only thing is that I had tried such loads before and noticed no deformation like this; so this was a bit puzzeling. :rolleyes: Kernel, if its so inapproiate then maybe you should notify Speer so that they can remove a such inapproiate...

Winchester's are semi known for cra**y barrels. Their proof steel is not homogenous enough. I can guarnatee its not stock/barrel interference; if anything its a bad barrel, might just pony up for a Lilja.

actually that load was a dead rip off from the Nosler book. IMO the lyman book while regared by many as the bible has some of the wimpyest, least performing, lackluster data of any published load data book. While I use it for reference for case dimsions and such, I generally refer to a book...

your flaring die is set too deep, and over flaring the case mouth.

barrel is completely free floated from the reciever to the tip of the forearm. My gun must be a bit finicky then. As I have to use faster powders to get sub 2" groups at 100 yds, and I am looking for groups less than .5"@100. My best to date is with Win748. The factroy loads are Win760, and...

My personal favorite is IMR 800X b/w 6.3-6.7gr Posted for reference only, do not use this information w/o knowledge in reloading, and start at min 10% and work up.

I have a winchester Mod. 70 .300 WSM Super Shadow, that has a rather peculiar trait. On a cold bore it will shoot approx. 3" hi/left, after a couple of shots 3 or so it shoots to point of aim in .25" 3 shot groups. It will continue to drive tacks as long as the barrel is hot. (all numbers @...