Search results for query: *

Tony, Sorry about the confusion, the initial rounds I built would fail to chamber. The rounds I built would feed but then stick (I'm assuming because they reached the rifling) out of the chamber a little and keep the slide from returning completely forward. When they did slam all the way in...

Full disclosure, I'm a relative newbie to reloading and the workup I did for 9mm was my first, but the biggest problem I had with that workup was the COL issue. Below is a link to the discussion here that I started about it: http://thehighroad.org/showthread.php?t=485712&page=2 That said, I...

Followup So, after a few nights of manufacturing and a few trips to the range to test out my rounds, I think I've found my "temporary" formula: Winchester or Federal once-fired Brass: .748-.755" length Winchester Small Pistol Primers Berry's Plated HP 124gr 9mm (.355" width) Alliant...

Just a quick follow-up Loaded up a few rounds today and took the pickiest of the guns (P6) to the range to try them out. Again, used Winchester once-fired brass, Berry's 124 grain plated HP bullets, and Winchester small pistol primers. OAL of all of the rounds was 1.078" (+/- .2"). I...

Just got back from Midwest in Lyons, IL. The had a few various boxes of Winchester primers left including 2 boxes of small pistol. They wanted just over $33/box but considering I haven't been able to get them anywhere else, I bought what I had the money for.

First of all, thank you all for the quick responses and the wealth of information. My purpose for reloading is cost savings, as I shoot a LOT of 9mm, primarily practice plinking and competitive target shooting (IDPA, USPSA, and Bullseye). I realize that 124gr JHP isn't the ideal bullet for...

Will order a case gauge later this week. Beretta is a 92fs INOX. Beretta allowed round to chamber right around 1.140" I've gotten rounds to chamber in all my 9mm firearms consistently by reducing OAL of the rounds to 1.075". The pickiest barrels were from the P6 and XD, which both needed...

Reloading newbie here with what I'm hoping is a newb question. I'm trying to load 9mm 124 grain JHP rounds but having trouble and not sure what the problem is. Details are below but the problem is the round is failing to completely chamber and then keeping the slide from closing. This...