Search results for query: *

Finaly, I have settled with a load of 5 grains Vectan Ba9 (= +- Unique) and a 110 grains RN copper coated bullet from Frontier (South Afrika), with a small pistol primer. This is a fine load, very accurate en fun to shoot !

Thanks everybody !!! This forum has been very helpfull ! Grtz, John

So I could use 32-20WCF loads. gmdr.com/lever/ gives loads with VV N340 and a 115grains RNFPbb bullet. Can I use those loads in 30M1 with a 110gr FMJ bullet ? Grtz, John

Thanks Bob, this is very usefull !! Rc, when I use a given load for a FMJ bullet and use it with a lead bullet, I will end up with much higher pressure ! But when I use a given load for a lead bullet and use a FMJ bullet instead, this may be safe to use ! Correct me if I am wrong !! Grtz, John

RC, I had found a load ; Ramshot True Blue 4,5 grains for a cast lead 115grain bullet. VV burning rate chart gives True Blue same rate as VV N350, but N350 like's some pressure for clean burning. But I find nothing to check those figures, I have FMJ bullets but I don't thinck that makes a great...

I live in Belgium, and most "common" American powders are hard to find here.

Now I reload 9mm Luger, 45ACP, 357Magn, 38Spec, 44Spec. and the powders I use are VV N340, VV N350, Vectan Ba9 (same burning rata as Unique), and Hodgdon HP38. What can I use ?? Grtz, John

I need a light load for a 30M1 cal. Blackhawk revolver. The STD flodder makes too much noise in the indoor stand. I have 110 grains FMJ bullets. Thanks, John