Search results for query: *

A friend of mine dropped this off. No bolt. Definitely looks arisaka but wood goes to end of barrel vs almost to the end. No wood on the top of barrel. Any ideas

Great info. I think you are correct. Thanks so much getting me the info.

Does not look like a typical arisaka.

A friend found this rifle at his fathers house. Any ideas.

thanks for all the advice guys. i have not disassembled one so i need to check it out. might be just a cleaning. the primers are good and flush though. i know some primers are tougher than others. thought i would try some commercial 308 too just to check. will let you all know what i find...

good info

good info

totally agree.

totally agree.

I have an M1 Garand in 308. Got it from an old man at church who was 90 and shot in matches in early 60’s. So I have been shooting it for couple years single shot. So today I used a clip and on the 4th shot I got 2 shots. Loaded clip again and it happened 3 times on that clip. Uggh. I reload...

Rcbs

great info. yeh it all shoots very good. cycling etc. just did not like the soot. i need to actually look at some factory ammo and compare. i did not crimp which is nice. they look real firm in the mouth. i might try like you said to insure that the flare is not to much. to me that would account...

I just started reloading 9mm. I resized and insured trim etc. I belled the case just enough to get bullet in. Then seated the 115 gr bullet. Using unique with 5.5. I did 4. All chambered and extracted fine. Primer looks good. I did notice some smut on each side of brass after shooting them. Any...

I ended up sending mt rcbs dies to rcbs and they modified

a2 is great. And you dont need all those darn optics. The rifle will shoot:)

So. If you reload what do you have - 223 or 556. What is the break point and size bullet. Seems the longer throat allows longer col. Just curious

Funny i bought one this week end. Made in the 50's. Nice rifle. I dont like the rear site though. I tried to get it sited in at 100 yards and it shoots low. Not enough adjustment in rear. It would require shorter front site but it is fixed. I went to 50 yards and shoots within 2 inches. Was...

Yes the loads all closed fine with the bolt. Just fist time my book has been so wrong on a load. Going to try h1000 but not easy to find till next gun show. Ugggh. And start low :)

Sure appreciate the info guys. I was sure reckless on this one. The load data is from the 5th edition sirrea reload manual. Very clear. And it was for 300 gr sierra hpbt. Again dumb on my part. I shot 10 and no joke at 200 they were almost same hole. I have stopped belive me. I did call sierra...