Search results for query: *

Out of 100rd yesterday I got 15 that blew out. Is this something that I should worry about? I have been using this load for about a month now and no issues with WSP or CCI pbrands. Load is 4.5g AA#2, 180g TCBB lead moly coated, 1.115in COAL. Gun is a glock 22 40 S&W with a Wilson Combat...

Does Narrow and Wide have anything to do with the actual width of the front sight? Looking at pichers in the midway catalogs the narrow looks shorter front to back. I assumed narrow vs. wide had to do with the tenon length, not the actual width. I have a Colt M80. I thought it was by...

Just curious. How long can you leave powder in the hopper of a powder meter before worrying about moisture? If it sits overnight do you still mix it back into your bulk jug?

Anyone have any data or loads for these? I picked up a box at my local pawn shop. Look to be a good hard cast lead projectile. Figured I could pick up some basic data on their site. Nope. It is very similar to the Lee 452-230-TC from their 90290 mold. Magnus no.803 225g TCBB .452 DIA...

Picked up my NIB Glock 20 SF last week. Haven't fired it yet. Purchased from one shop, took off the slide and left that at another shop to get night sights installed. At any rate, I look at the frame this evening and am struck by a slightly odd looking ejector. Aren't these normally...

I have gotten into a debate with my father over this recently. He basically warned me against posting images of my firearms on Facebook. I told him that my facebook images are only visible to my friends, so that is a non-issue there. However I would keep that in mind on my blog, which is...

I have been considering selling off a couple of guns, both near new <150 rounds processed and in their factory box/case. Guns are a vintage ~1978 Beretta 92S (purchased ~1980 for $300) and Taurus PT845 (purchased in Oct for $320). Yesterday I got a wild hair and pawned them off. I got the...

Not sure if this is the right section to post this, but here goes none the less... I purchased the cheap Plano 4-pistol case last week to transport some handguns while flying (model #1404-02). The end result was somewhat less than impressive :barf: The case broke/cracked in one corner...

Did Winchester ever make the m290 in a .22WMR (magnum)? I was at a local pawn shop this weekend and looking up on the wall I saw the usual suspects, but walking down the .22LR section I noticed one of the tube fed rifles had a much bigger cartridge hole than the others (about 1/2 again...

Hey guys, any recommendations for non-smith drilled scope mounts for a tapered barrel 22LR. Gun in question in a Winchester model 68. I know Weaver makes compatible adapters, but they do require a gunsmith to drill and tap it. However the gun already has a botched set of drill holes on it, so...