Search results for query: *

I'm considering a Hiviz FO front sight for my SW M13-2. The existing front has fairly short height, sloped ramp, pinned front sight (~.20” high) and a fixed grooved rear sight. Brownells has hiviz listed for "SMITH & WESSON REVOLVER - Replacement front sight"...for K, L & N frames. They...

Thanks Old Fuff... I just got off the phone with SW Support and it's going back for service. They informed me that their lifetime warranty did not begin until 1982, so this 625-8 (1978) is not under warranty (regardless of first/second owner status). Appreciate your expertise. smsdba

Old Fuff/Iron Bottom.... Thanks and it appears your thoughts on timing were correct. I put in snap caps and fired in 2B action. Everything is fine while pulling the trigger slowly. But when I speeded it up I noticed the bad cylinder was ending up in between, and also found primer strikes all...

SW 625 - .45 ACP, moonclips, bought used from a friend. First day out with it and hit this problem: Consistently fails to strike the primer on one cylinder, and occasionally on the one just behind it, in double action. In single action, no problems. This has occurred with different ammo...

Anyone have any data for .38 special, 147 gr RN Plated? Here's what I've worked up so far: 3.8 Titegroup, 147 gr RN Plated, Fed Brass & Fed SP, 1.46" OAL: Hi - 772 fps, Lo - 723 fps, Ave - 742 fps, Ave PF - 109,100, StdDev - 15. 3.8 Titegroup, 158 gr RNFP Plated, Fed Brass & Fed SP...