I was testing 3.6 n310 with 200 grain Oregon trail swc. I am looking for a light recoil with a spring field range officer with the stock spring. I am not sure what the weight of the stock spring is. I am in a bullseyes pistol league and am only shooting a 22lr at this time.
I am new to working...
Thanks Guys
You have anwsered what I was wondering about. That it seems to get a light target load I am going to experience some sooty brass
Thanks Again Craig
Hi
I have been working on some target loads for 45 acp.
Can someone give me advice or tell me about how to interpret the powder marks on the brass after it has been fired.
I am trying to find lite loads, but I thought I read some where that if the load is to light the brass might...
Thanks Guys
I will read the articles you mentioned. Right now I am disappointed with mp 9mm. At 50ft I am only getting a 12 inch group. I was hoping for more but maybe I am not being realistic.
HI Folks
I am starting to load 115 gr Penn swc's in 9mm. I am worried about leading. I am putting them through a SW mp 9mm with 4.25 barrel. I have never seen leading and am not sure what it looks. How do i know it it is leading?
Thanks Craig
Hi folks, I have an ruger mark 1. I am using it for bullseye target league. I was wondering if the volquartzen trigger kits for the mark 2 fit the mark 1 or is there a special kit for the mark one.
Thanks Craig
I am starting to load 9mm swc115gr. .356 penn bullets with a lube ring. I have never loaded cast bullets with a lube ring. When I talked to penn bullets the guy said that most of the people that he had talked to for overall length seated the bullet to about a thumb nail width below the shoulder...
Hi I bought a tasco red dot scope for my Mark I ruger 22 rimfire pistol. The one that I bought stated that it would fit rim fire and airguns. I have since bought a couple of bases that are weaver style bases. They are way to wide to fit the clamps on the scope. Can you give me any advice on what...
I am starting to pick up brass at the range. Is it important to sort the brass by brand or is it OK to just make sure they are all uniform with one another?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.