Thank you guys for your kind words and support. I am glad you like the gear! Always nice to stumble upon a review thread. Pretty cool to be able to read the reloading threads, learn more about reloading and be able to support/appreciate customers at the same time. :)
Dan
InLine...
Every once in a while one of those gets out. Out of spec internally. Problem being you can't tell until it slips off. No worries, please look me up at [email protected] and I will get you out a new one with a quickness. :D
Done. I have made double and single bin brackets. The improved bracket can be used with or with-out the Ultramount and also supports the case feeder actuation rod. :D
Nice press set up! :D
I have been toying around with making a better bracket to replace the weak\rusting factory Hornady finished bullet tray bracket. Mine bother me with how they sag with just a few rounds in them and seem to be very susceptible to quickly rust. Would that be something...
This is great to hear! I am glad it is more comfortable for you!
Thank you guys for the compliments, I appreciate it and really value feedback. If you have any questions or concerns, please don't hesitate to ask.
Dan
Yes, That's an odd one. I suggest you call up Hornady as well.
Unless you didn't swage them quite enough? Grab a piece of brass that you already swaged and use a regular countersink to remove a little bit of brass. Then try to prime that piece of brass and see what happens
A "new to reloading" buddy of mine brought over some rounds that he had loaded and asked me why the primers have a dent right in the middle of em? :eek:
We went over to his house so I could check out his primer seating pin and found a .015 high "post" right in the middle of it, left over...
Great post Bob!
I removed the primer slide from my press and lightly chamfered the bottom of the leading edge to give that one rogue piece of powder somewhere to go and not stall out the press.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.