Search results for query: *

  1. R

    No powder ?

    You just have to keep looking I was able to find over 50 lbs of Bullseye recently for myself and some friends.
  2. R

    What's Wrong With Polymer Framed And Striker Fired Guns

    I have some of each and prefer the weight of steel guns over the polymer but for pocket carry polymer is great.
  3. R

    Question for the 45 ACP reloaders

    I use Missouri 200 GR SWC and 4 gr of bullseye. No problems with my Kimber Raptor II
  4. R

    Tula Primers...any good?

    I tried them (LPP) last night in my Hornady LNL and they were very difficult to feed. I could not get more than 5 in a row without them hanging up and not feeding. I have used a thousands of Winchester with no problems ever. I am regretting the purchase of 5,000 i ordered. Its going to take a...
  5. R

    Zero Brand Bullets?

    Both the sites are up now. It does say they are very busy and backlogged about 6 weeks.
  6. R

    Hornady LNL caliber change?

    Hello all, I have been reloading for about 1 year and have only reloaded .45 acp and would like to start reloading 9mm. What is the easiest way to change calibers without resetting or adjusting the case activated powder drop? Should I just buy the powder drop and case activated die or can I...
  7. R

    RP brass in Hornady LNL

    Thanks for all the replies. I am using .452 lead and the PTX from powderfunnels. I have the PTX set so only a very small belling occurs(probably could use a touch more). I will try and seat a bullet without the PTX and see what happens.
  8. R

    RP brass in Hornady LNL

    I have a LNL press and have reloaded about 600 rounds so far in 45 acp. I have been saving brass for a couple years so I have a mix of various makes however the RP brass is not working for me. I set my press up and have had a problem with only this brass I cannot get enough tension to keep the...
  9. R

    Hornady LNL Progressive

    Thanks all. I will loosen the shroud and use some graphite.
  10. R

    Hornady LNL Progressive

    Recently set up the press and I am having problems with the primer feed. Loading .45 acp and the primer arm gets stuck open and has to be tapped on to return to prime the case (win primers). Any ideas? I called Hornady and they said "that should not happen"... They did offer to look at it but...
  11. R

    .45 acp using hornady LNL AP

    Rookie here, and would like to know what type of crimp for 200 gr lswc should be used. In the process of setting up and will be using hornady nitride dies and power cop die. Is the crimp/seating die ok or should I use a crimp die seperate from seating die. Thanks in advance.
Back
Top