Search results for query: *

I'm wanting to do a new AR build this year, and I've narrowed it down to .308 and 6.5 grendel. I have only read on the grendel, no actual experience with it but I haven't found a lot of negative threads or articles on it. The .308 is obviously a proven choice, now I just want to ask if anyone...

I'm going to build a 6.5 grendel AR this winter, any recomendations on die sets? I have no experience with this round but from reading I find it interesting and would find any experience and advice sharing helpful, thank you

I am very new to reloading, I have made several loads to see which works best in my rifle, but have yet to test them. I am going off suggestions in the reloading book, using their powder charges, oal, bullet and whatnot. I have read a lot on this website about loading to the lands, or just off...

I'm sure this question is going to sound stupid to you seasoned reloaders, but this is my first batch so I am trying to be extra careful, and I trust all of you out there. The suggested OAL for the load I am doing is 2.200, I'm using 21.6 gr of H335, and SR-Mag primers. Anyway I was wondering...

I guess I should have titled this 'not trimming' because my question is this: I have a bunch (2500) once fired brass. After measuring it all, I have quite a few that are below 1.75, which is the suggested trim length. Many are 1.74, and some are in the 1.73 range, so I'm wondering if this is...

Hey everyone. Just got started reloading. I've been doing .223 for my AR, now I want to fill a bunch of brass I have for my other love, my REM 700 .30-06. I've mostly shot 150 gr. Core lokt out of it, but was wondering if any of you have tried 110 gr. Sp's? Any other recommendations?

I'm doing some reloading for the first time. I bought 2500 1x fired brass, and maybe 10% or so have small dings on the side. I'm wondering if some are ok still or if any size of ding makes it useless? I threw out about a dozen or so for dented shoulders and bad necks, but other than that just...

Hey I'm new to reloading. I've been reading some books and watching some videos....I have cleaned and re-sized and primed about a hundred rounds, just looking for some advice on some loads you all may have tried that have worked? I have Hornady Spire points w/cannelure and they are 55gr. I have...

Hey I'm new to reloading. I've been reading a lot and watching videos, and I think I'm gonna start loading some .223 rounds this week. I will be using BLC-2 powder, and was wondering how long the powder keg is good for once the seal is broken? does it go bad? I wouldn't think it would but I want...