Search results for query: *

Ok, I had another thread in the general section asking about ballistol and cleaning corrosive ammo. As part of that thread it was suggested that I quit worrying about whether or not I need to disassemble the bolt and just do it so I can clean off the firing pin, etc. That being the case, I'm...

Yeah, I guess the simple answer is just to figure out how to disassemble the bolt and see how easy it is to do. Was doing some searches on the web and not finding much info on how to take the bolt apart --- guess I'll start another thread in the firearms area asking for advice. Still...

Good discussion What are your thoughts about the bolt of my PPS43 and cleaning after corrosive. A youtube vid suggested not taking it appart but at the same time mentioned that you need to make sure you clean it to avoid corrosion... Doing some research on the web, it does appear that some...

Thanks for the advice (I will try the hot hot hot water idea). One thing that I'm still trying to verify though is with ballistol, if you do the 1 part ballistol to 9 parts water mix, if there was any water left over in hard to reach places, would it really harmlessly evaporate and leave a...

Question concerning using ballistol with blowback weapons such as the TT33 and PPS43c. I understand that I need to dilute with water to wash the salts out of the barrel which I have no problem with. My real question deals with getting the internals such as springs, trigger assy, bolt, firing...