I have both, the RCBS and Hornady. They both seem to work equally well, once you have them set up, and set up is not hard. I have re used every bullet that I have had to pull. I would buy which ever color you prefer.
I am wondering how many of you have used this and how well it works. I have reloaded for bolt guns for a long time and I am going to be processing LC brass. If you have any recommendations let me know.
When I have used factory ammo, I got mixed results. One box would give me some 3/8 inch groups then 1.5 inch, basically the same box was very inconsistent. This was from several manufacturers, for different cartridges. I usually get a box of factory ammo when I buy a new gun to see what...
I have a 243 wssm in a model 70. The factory loads are hotter than the max loads for the data out there. I would full length resize them, and then shoot. After that then you can neck size them a couple of times and go back to full length, etc... I usually check them after their second...
They shoot the best in my 223, they need a 1:12 twist to stabilize. That is why most 22-250's will not shoot them well. I did not care for the 50 grain vmax though.
I'll take it Redding 30-06 benchrest competiton seating die from above post.
My pay it forward item is a box of 87 grain 6.5mm speer bullets about 83 left in the box
The first I'll take it, followed by a PM with your address gets it.
Starline is taking back-orders for 357 mag brass again, when they get a large enough amount of back-orders, they will produce another run. Here is the sight
https://www.starlinebrass.com/order-online/caliber.cfm/caliber/357/
I have several load manuals to verify the load data with and I can also look it up at hodgdon or alliant amongst others. I am doing this to try and narrow my options for powders to try.
I was wondering if any of you would be willing to let me know your pet loads for the 40 S&W. I would also like to know what the best powders are for this cartridge.
I have a yellow box of spire point 180 grain bullets that say they are .3085 diameter made by Vernen D Speer.
.3085 - 180 - 6 - SP is what is marked on the side of the box.
They have a dimple on the base of the bullet. Are these hot-cors or what are they? They are in very good condition and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.