Search results for query: *

Yes, I make bread with ours.

.30-06

Exactly what I've done for my grandchildren.

TL/DR

As noted, give them a call. They've always been extremely helpful to me.

Yes, one early on (70s). Single stage, operator error.

Here are the images that were scattered randomly through the previous post.

I have used the attached system since 1991. Prior to that was note pads and index cards. This gives me everything in one place. I staple notes and chronograph print-out tapes to the appropriate cartridge lot number page. A sample of the container ID label is on the binder cover. I have a 2nd...

No.

I have never sold a tool. I did give away a feeler gauge to one of my sons though.

Back to the original challenge. I take the cartridge case from which I wish to cut off the head for jewelry, enlarge the flash hole as you do for wax or rubber bullets and seat the primer. Clamp case in a padded vise and cook off the primer with a propane torch. Haven't had a primer back...

My 550 and 650 each have the ball handle, which usually work just fine. When they sometimes get draggy, I wear a white, lightweight glove that I sort negatives with or use to handle fine firearms.

Thanks for the info. Downloading app right now.

Hornady One Shot. I read and follow the label instructions. Never had a stuck case.

My all-day-long, every day, prescription indoor and sun glasses have safety lenses. I always select frames that provide a greater than usual amount of coverage. There is a box of various sizes of child and adult safety glasses immediately inside the shop door, below the light switch. The...

Thanks folks! I wanna try this!

I hand prime for my single stage with an elderly, but strong, RSBS hand priming tool. I let Dillon prime on my 550 and 650.

Also consumer products. A Pringles lid replaced a lost cap for a camera lens hood. Maybe check kitchenware/storage at a dollar store.

No, it hasn't happened yet and I doubt that it will. Kinda fussy that way.