Search results for query: *

  1. C

    Once fired .357sig brass is shorter than spec

    I recently purchased about 1,500 pcs of once fired 357 sig brass (that says 357 on the head, not .40), but 99 percent of it is between .858" and .860" in length. The SAAMI spec is .865". Sizing it does not put make it the correct length. I haven't had any problems loading them, but the issue...
  2. C

    Barrel change caused point of aim to shift; Normal?

    Hey guys, I recently purchased a sig p229 BTFO (the one with the fiber optic front) in .40. In its original configuration it fires dead on. I purchased the Bar-sto 357 sig barrel and it was firing tight groups but consistently low 1.5" @ 15 yards. (1" @ 10 yards). I consider myself an...
  3. C

    Crimp mark on 357sig bullet acceptable?

    Hey guys, I am beginning to reload 357sig round and I'm unsure on how to go about the best crimp for this round. I've read the info on the pete's 357sig page (in the link below) probably 10 times, but I'm not having quite the same results he did. According to his tests the hard jacketed...
  4. C

    308 velocity dilemma

    Hey guys, I'm having a bit of trouble getting my 308 ammunition to register anywhere near the load data velocity using the prescribed loads. Here's what i'm using: Lake City brass 168 SMK IMR-4895 Win LR Primers Fired from an M1A Socom Data from the Sierra and Lee manuals The data in the...
  5. C

    Powder for Berry's 155gr .40

    Hey all, I've been lurking for the past year or so, learning the fine art of reloading, but now I need some advice. Previously, I'd been shooting 155gr Hornady XTP's (500 came free with my LNL, woo!) out of my HK USP .40, with Universal Powder and data from the Lee reloading manual. Now...
Back
Top