I did buy a set of Wheeler tips but you are right. I think the screw is already too far gone. I took the gun back to where I bought it and the gunsmith there couldn't get it either! I will take your advice and get a replacement screw for when/if I get the original removed LOL
Thanks again...
Actually no, these are not bits specifically for gunsmithing. Sounds like my 25-cent trigger job is gonna be a bit more expensive LOL
Thanks for the help :)
I'm all ready to perform a Flitz trigger job and I can't remove the screw under the cylinder. I've tried every flathead tip I have (which is many) and no go. The groove seems too shallow to get any leverage. I have managed to scuff the screw and the area around it ... not good because it's...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.