Thank you everyone for the wealth of information. Yes, it's for an AR. From the factory the collet was so tight I could barely get it loose again, may explain why the pin didn't slide up.
I love the idea of using the 9mm case for a quick check on the shoulder movement. Waiting on the case gauge...
Thanks everyone,
I didn't know anything about the collet holding the decapping pin, makes a lot of sense. How do I know where to set it? I think I pulled it too far out the first time and it crushed the necks, but I pushed the pin in further and it seems to not be doing that anymore.
The neck...
Hi everyone,
Very new to reloading, I'm trying to resize my .223 brass, but I'm having trouble. I'm using a Lee full-length sizer and I've followed the instructions to screw the die in until it hits the ram, lower the ram, and screw it in another 1/3 turn. I lubricate the case with the Lee...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.