Search results for query: *

  1. X

    Xds-45 3.3?

    I have owned 3 of them. I am a circus midget basically with small hands. It fit me perfect and shot excellent, no twist. My brother in law is a 6'5" 250 lb biker who has hands the size of a baseball glove. He cant hold on to it. I guess it just depends on who ya are.
  2. X

    Power Pistol, bought some for the heck of it...

    I find it very good in a 357 snubby. I burns fast, which is good in a snubby because you dont have barrel length for burn time.
  3. X

    How many Garand rounds wear off the grease?

    A Garand and a M1A pitches the brass anywhere from 1 to 3 oclock when lubed correctly. If it starts pitching 4-5 oclock, then she's dragging and needs grease. MyDad was a WW2 vet in the Ardennes, and that was the answer he gave me when I asked him that very same question.
  4. X

    should i buy this?

    I don't think Crossbreed makes a IWB holster for that yet.
  5. X

    Favorite short barreled revolvers?

    649 S&W Jframe 357. I removed the factory rubber grips and installed old school wood model 36 grips with a Tyler Tgrip. Stings the palm a touch with Barnes 140gr Vor-Tx loads
  6. X

    Could Gun Rights Opinions Change This Quickly?

    The only possible option, would be harcore regulation by Executive Order. But if anything could have budged it, it would have been Newtown.
  7. X

    Why did you start carrying a gun?

    I am 55 now, but when I was 18, I worked construction. I stayed late to finish hanging a drop ceiling grid, and got robbed by a guy swinging a bat with a knife taped to the end like a bayonet. He was actually gonna kill me for 6.50 and a Exxon card. I bought a used jframe and that was the start.
  8. X

    Do You Carry Concealed into your Church?

    In VA you have to have permission to carry into a place of worship during services. Luckily, my Pastor is my shootin buddy. I told him I was gonna start carrying, he said OK, but 1 favor... Keep it concealed well so nobody else knew. I said Fair enough.
  9. X

    The bodies are NOT cold yet....

    Well, here we go on another gun / ammo run.....
  10. X

    Kicking and screaming into the 21st century

    As you can tell, I'm an XD guy. However, I must say the Glock 19 & 26 are two daggone fine pistols. I would trust my life with either. And the best part,... The more you shoot them, the better they get.
  11. X

    By the time she learns a lesson, it'll be too late.

    Hahahaha, so forcing her at knifepoint to face all the soup cans foreward and in alphabetical order is a bit much?? :D
  12. X

    By the time she learns a lesson, it'll be too late.

    See, the bad part is... she lets it get this bad without saying anything. If she would just say, Hey how bout a cleaning, No problem. She goes out to shoot it and it jams cause of all the junk in it, and she wants to go to the gun store and buy her a new one cause this one failed and she lost...
  13. X

    By the time she learns a lesson, it'll be too late.

    I just don't know how to put it to her any clearer that you cannot do this to a pistol and expect it to work. :banghead: I go thru this twice a month when I do a disassemble / clean on it. Pocket fuzz, enough to make 20 pairs of pants. She refuses to use a pocket holster, and carries this around...
  14. X

    What is the most cherished gun in you collection

    Dad's Winchester 1200 Trap. Not worth much on the market, but every gun in that safe can go before that one does.
  15. X

    Bullets coming loose...

    If you do reload, might want to look into one of these gizmo's. I reload 9mm and others and found that alot of bullets I like don't have a cannelure from the factory. It has helped me alot. The crimp locks that bullet right in with a cannelure.
  16. X

    have you ever seen a lcp malfunction with fmj ammo?

    Hey Huntsman.... any updates?? You replace the spring & rod??
  17. X

    Where is the FBI load?

    Buffalo Bore... That's good stuff right there. Their loads with Barnes copper bullets are awesome too.
  18. X

    Say hello to my LITTLE friend....

    Yea, if you look at the pic, it has hammer rests milled into the cylinder between chambers.
  19. X

    New .45

    Too clean... you need to dirty it up. That's sweet, I'll bet it's gonna be a good shooter!
Back
Top