Search results for query: *

You should not be "grabbing the gun" from her hand you knucklehead.

Dirt sensitive? If I were you, I would ditch the cz and buy a reputable piece such as a sig or h&k, or even a glock. As is often true in life, you get what you pay for. Let the cz'ers continue to tinker away and feel relief each time they return from the range without a malfunction. Forums...

del

Lots of regurgitated uninformed opinions here as usual. Many have been reloading steel cases for years with no ill effects even before "the web" existed. The best forums in those days were on usenet news and a few dedicated bbs's. I hopped on usenet the other day for old times' sake and it's...

I sent mine back to Century because it would do the same thing as well as not feed HP's. They sent it back to me 2 months later after grinding a rough "ramp" into the bottom of the chamber. It still deforms bullet noses and feeds HP's about half the time. Down with Century!! Don't buy from them.

I was thinking about using a charge of pistol powder and keep velocities about 1000 fps. Do you think the oversize 32-20 cast bullet (.313) would pose a safety hazard in an sks with a bore .310-.311?

Happy New Year everyone. I see Oregon trail makes bulk boxes of 32-20 bullets, advertised as .313. Has anyone used these to reload for 7.62x39? How did it work?

The celebratory tone of the news media over the death of a man is despicable. As if any wrongs were corrected by this. Has man become any more civilized in the last thousand years?

Don't toss empty wolf steel casings in the trash. You could get raided on suspicion of having dangerous automatic weapons in your home. Watch out, junior may be "holding" a baggie for someone at school. You will never know until they raid you and confiscate your guns (including evil assult...

WWB 38 special FMJ? I've asked the same question and the consensus was not to use it in a tube fed lever action. I wish they were wrong.

Pull out those socks again!

Starting reloading with a high pressure cartridge and a progressive: recipe for disaster.

What you need is... a new "gunsmith".

I have hogue monogrips on one of mine. Very comfy. However, it didn't fit well when I bought it and had to use tape shims on the inside as well as a little razor blade to trim.

MFS works good for me. A few times I had to set my decapping pin deeper in order to decap.

Amerc is short for American ammunition, made in the states. About the most inexpensive stuff you can buy, even cheaper than Wolf. I have not fired it in 45 acp due to all the horror stories. Comes in a blue box last time I checked.

The Good: accurate, reliable, inexpensive gun which shoots inexpensive ammo, lightweight. The Bad: horrible DA trigger, frame wears quickly after extended firing, heavier wolf doesn't feed as well, tiny sights. The Ugly: Ouch! painful to shoot - talk about recoil. One of the cheapest ways...

If Taurus warranty repair turnaround time is any indicator, it should only take them a couple of years to cough up a spent casing. That is, if they can manage to remember which gun they fired it out of.

limpwristing.. uh yea, sure.

Don't buy a gun off the internet. There're many scoundrels out there. I may be missing something, but was that ding not apparent on the seller's photo? If not, he should have mentioned it - unless he's a scoundrel.