Search results for query: *

Yeah, I'm pretty happy about it all so far, I still need to put a couple hundred more rounds through it before I'll feel it's 100% reliable, but yesterday's short session (without issue) went a long way towards that.

As promised, Ruger sent my .40 back to me today and straight to the range I went. While unpacking everything I noticed that the first note from the Tech was that they had replaced the extractor and test fired a total of 30 round using both the 9 and 15 round mags without failure. I only had...

Should be getting mine back from Ruger tomorrow, heading straight to the range, will report back.

Psa1m144, Any update, have you gotten your pistol back from Ruger yet? I spoke to customer service and mine was with a tech and they expected it to be shipped back next week, really looking forward to seeing if they replaced the extractor or not.

I had this same issue with a Taurus .40 that I was using as an EDC, very annoying to say the least, felt like everybody could hear me coming and going; the solution was as rcmodel notes, to empty the mag and reload it, making sure to seat each round by tapping the mag on the palm of my...

Well, I spoke with Ruger yesterday and was told that the 1420 vs. 1422 part numbers on the extractor really have no bearing on the function of the gun and are not the culprit for the failure to feed issues. (the tech I spoke with even told me that she had received several calls recently about...

Thanks Psa1m114, apply a little pressure allowed the extractor pin to pop out....and sure enough, what did I find, but the 1420 extractor and not the 1422

Yep, that's what I've been doing, I can get the pin to move a fraction upwards, but not enough to release the extractor, just thought there might be a little trick that I'm missing

I've had a few of these same issues with my new SR40c as well, I'd like to check the part number on my extractor, but can't figure out how to remove it; can somebody give me some tips? Thanks