Search results for query: *

Agreed on the green, wicking type Loctite. Just an update ... The material that the Trijicon rear in this sight set is made from is not very amenable to filing (nor taking cold blue). Not like a standard "iron" sight. Suffice it to say that I essentially just ended up drifting the rear...

You've installed them so I will take your advice and will file/fit first. I'm almost tempted to drill and tap for a set screw just for some extra insurance. Then again, I'm not even 100% sure I want to install this sight. I staked in the tritium front but Im not all that big on...

Asked on another forum, no joy so trying here ... I'm replacing sights on a combat commander. I've installed enough sights before but have a question specific to these (Trijicon brand). This is the rear for gov. dovetail. Normally, I would file to achieve a press fit 1/3 or maybe a hair more...

My project gun, a combat commander, is ejecting brass straight up too high. On the bright side, it's ejecting it and it's pretty consistent :D I need to fix the trajectory though. I'll be fitting a new FP Stop and probably a new extractor. The existing extractor is clocking pretty bad...

Posted this on another forum as well (thanks for the help on both BBBBill.) Wanted to follow-up here as well. I dropped in a different trigger ... solid as a rock at half cock now. More to be done but good for now ... thanks all. Very much appreciated. :)

Sear/hammer look good on pins on outside of frame and contact looks good and even. The shim pretty much trashed the factory sear (burr around sear pin hole). I'm gonna play with some spare parts. Thanks

Working on a project gun. Colt MKIV series 80. Not a sample of Colts finest work. Problem is that the trigger pull drops hammer from half cock. I know this would be normal if it were a series 80 hammer but it's not the original series 80 hammer with the low/flat half cock shelf. The...