Search results for query: *

class3weapons.com sells gemtechs. I personally have no experience with them. The dealer I use is based out of Baytown. Good luck on the CLEO as well. I went the trust route due to living in Harris County.

I have a feeling that most people will say the same as you. I had always heard that a MAC is terrible in the accuracy department but I have good results with it. I don't know much about the Vector other than what I have read but I thought for sure it was going to be different. The rate of...

Is it odd that on full auto I am more accurate with my MAC? It is an interesting weapon as far as design and operation but at first glance I thought for sure it was going to be more controllable. I was shooting at roughly 12 yards and with my MAC I can dump a mag into the center. The dang...

Here is the 870 and the MAC. Thanks again for all the input. I just got done giving it a good oil and clean and we are headed back to the range in about an hour. Hopefully this will solve some of the problems. I will definitely be cocking the bolt before inserting any mags this time. I will...

Thanks for your responses. I was using a Cobray mag and and also a modified grease gun mag. The Cobray mag was the one being used when the single round went off. My first thought was that I did engage it by charging it with the mag in although I don't have too much experience with the open...

Hey everyone. I'm new to this site and I had a question that I was hoping to get an answer or feedback on. I just recently received approval for my first two NFA items. I purchased a Powder Springs M10 in .45 and also a SBS. The can for the mac went pending on January 29th so unfortunately I...