Search results for query: *

So I was cleaning my mosin nagant... used boiling water to run through the barrel and onto the bolt. After running the patches through the barrel, I realized that the bolt was still wet. Me being lazy, I decided to do something I now regret. I had the oven on at 300 deg F because I was drying...

So last weekend (june 9) I went and shot my mosin nagant. I put only about 10 rounds through it. I took it home, put windex through it, dried the barrel. Ran Hoppes through on patches many times. Ran dry patches through. Ran oily patches through to finish up. I look at the bore today and...

Hickok45 says so... I have... have you?? http://www.youtube.com/watch?v=Xfb1HIKVYVA

voted 90% :D

Cool thank you all so much for your helpful replies!.. Do any of you have any idea of whether I should stick to the buffer and buffer spring which I got from a gun show... they seem to be perfectly fine.... but so did my buffer tube

Im 19, so I haven't had this rifle for more than 9 years and I would estimate the amt of ammo I put through this rifle to be only about 800-1200, so I doubt that it's wear on the hammer or sear. 115grfmj, I think that might be getting somewhere..... tomorrow when I get a chance to strip the...

Now I know that this doesn't replace sighting in with live rounds, but should I pay the 11$ for this little gadget on amazon? Do they actually work well? I just recently finished an AR15 build and have yet to take it to the range... It seems as if the laser device could alleviate some...

when i disassemble the rifle and cock the hammer, I can clearly see the sear engaging the hammer... however when I cock the hammer, It does seem to have more tension when the hammer gets closer to engaging the sear.... so maybe I could be fixed with adjustments the the hammer spring

68WJ, what exactly do you mean by "ensure the bolt comes back far enough before bottoming out" Thanks.

Ok so at this point I agree with NY and Friendly... Before I tightened the castle nut on the receiver extension, there was a good amount of play between the lower and buffer tube when I had it screwed into its current position(not sure if this is normal). As I have already spent 4 figures on...

I forgot to add this, but It could be the reason for this malfunction. I received this rifle when I was pretty young (like 10-12) and I read through the manual thoroughly before operating it, but the manual never discouraged dry firing, so naturally I assumed it was safe to do. Not until about...

Ok so ive been having a bit of trouble with my marlin 795 semi-auto carbine. For about 50-30% of the time i fire the rifle with a variety of ammunition (cci, federal, remington, blazer, etc) the rifle will fire, eject the casing, chamber a new round from a magazine, but without cocking the...

Ok thank you all for the quick responses. First of all I bought the buffer tube (have no idea who the manu. was) at a gun show on a whim and in retrospect, I realize that I should have done a little research, as this tube is slightly out of spec. I did think about purchasing a new buffer tube...

OK so to finish my first AR build, I removed an A2 stock from a RRA lower receiver and replaced it with a mil spec buffer tube with a magpul CTR stock on it. When I screwed the buffer tube on to cover up the buffer retainer pin, the tube would only cover a small portion of the detent spring...