Well, I just couldn't get the cylinder in. My wife and daughter-in-law were sitting at the dining room table, so...I decide to give them a crack at it. In it goes...go figure.
New Uberti 1858 Army. Cylinder removed on left side, should had been on the right side. Can't seem to reinstall cylinder using directions (install in the right side). Cylinder goes in only so far (¹/³ of the way). Tight fit, can't rotate in place) Ideas? Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.