My sister found a bunch of old reloading stuff in her new houses basement... This was there... I got nothing.... Anyone? Also found what looks like a misfired .50 tracer round made in the Utah plant in 1042 pretty sweet!
Ok, pulled bullet, broke kinetic bullet puller pull sliver of plastic out
Of my tongue and this is what I found.... I ran case through resized again and it. Ow fits in chamber no problem. I chamfered after trimming but what the hell happened to this bullet? You can't feel it but you can see it...
Thanks, all good stuff I do make sure
I resize then trim, no expanding mouths. Involved. I'm gonna pull bullets and reset see if I can track down issue ill let you know in a min what I did wrong and if I fixed it!!!
I chamfered the insides and barley put any crimp on em as they are going in a bolt gun, but you are probably right. If that's the case is that brass trashed?
I just got done loading a batch of .308 did a chamber check and it seems like the rounds are too big!!!! I almost have to force the bolt all the way closed and its hard to extract. I full length sized them stuffed a primer in and 45gn of varget on top of a Speer 150gn spbt
To the Speer specified...
I think It should work. Normally 38spl dies work on 357 it's the 357 that won't work for 38 because of its height. Should be able to back out the die enough. It's not
Marked 38:357 on the die?
Thanks all, obviously I had no clue. I don't even own a 45-70 my friend has a 45-70 derringer I figured 45 colt and 45-70 might be like .38/.357. Thanks for clearing it up!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.