Search results for query: *

Thank you, sir! The rifle in question is owned by my neighbor, so I'll fetch it from him, adj. the lips as needed and see what happens. I'll let ya know how it it went and take a few photos to try and show what I did for the benefit of anyone who's been following this thread. Wolfgang

Natman: I hesitate since you've helped out so much w/ your comments & photos, but I would like to ask another favor from you. Do you have the means to measure the lip openings at the front and rear (in case there's a taper) of both pairs of lips, so 4 measurements total? I fixed the mag drooping...

The parts you show look to be exactly like mine and I have them installed the same way. I'm fairly sure I have the correct magazine and it feeds the rounds out relatively easy. If you have the time & inclination, please post a photo of your mag so I can verify that I have the same. Is the...

I already have the spring bent out so that I can just barely get the mag in. It just won't hold the front of the mag up during loading of a shell. ? Wolfgang

I finally found a mag. However, the problem is now that there appears to be no provision for holding up the front end of the mag. There is just a flat spring to keep it from falling out, but not enough to keep it in place, esp. for the first couple rounds. The rear of the mag does have a...

Unfortunately, that is the new style. They're out of the old-style. But thanks for looking! W

Have one of these in and it needed several parts, incl. a magazine (23B is for the .25-20 cartridge). I figured there was no need to order the other parts unless I could get the mag also. I finally found & ordered one from Triple K and after a couple days (to make sure they were actually sending...

Have one of these in and it needed several parts, incl. a magazine (23B is for the .25-20 cartridge). I figured there was no need to order the other parts unless I could get the mag also. I finally found & ordered it from Triple K and after a couple days (to make sure they were actually sending...