Search results for query: *

I am currently sitting at 5 months (Feb 8th) for my 3rd of 3 submitted that day. Still "Processing" same as it has been.

Only you can determine what you wish to keep. Your guns, your choices and all that. I am an AK guy, i have several in different flavors from 7.62x54 down to .22lr and everything in between so all I will offer is my take on them. My 5.56 AK is an older Romanian SAR III imported during the ban...

Yes, all corrosive. Can't tell true value without knowing the headstamp and if there is black sealant around the bullet/case neck area. If steel core, worth more than lead core. Not that steel core is AP at all, but some will pay much more for it.

It's all relative. I am a big AK fan, have a shoot a few. Accuracy? Well, most all of that comes from the cheap ammo. Use good ammo, an AK will be just as "accuracte" as any out of the box basic AR. It's like getting a nice bolt action .308 then shooting surplus M80 through it. Accuracy will...

Same here, Patricia "Wiggins" (last name not clear) on the first one, Heather W. Mills on the second.

PDF form in e-mail

Got the second of the three I submitted on 2/8 back. Exactly one month apart. Hoping I don't have to wait another month for the third and last one I sent them. E-form, paper prints. Still love how they state FIFO, that is so not the case with mine. 1st one (AR15) came back 4/18 = 75 days...

I officially hit day 90, and still counting on two of the three. Submitted 2/8 (self e-file). At this rate, my paper form 4 will come back before these do. The tin-foil side of me wonders if they are waiting till after the end of the month, come up with some BS reason not to approve then say...

What is the mess inside the upper? Step 1, clean it. Other than where anodizing has worn, should be original finish on the inside. check for burrs and gouging. Step 2, What you are describing is most always gas related. Ensure barrel has gas port, gas block is not blocked, gas tube is not...

Some if I think comes from little things like where ATF says "processed in order recieved". But then of the three I have in, the aproved one is the last of them in order, but haven't touched the first two yet. Then there is, if all three that were done on the same day, at the same time...

Got 1 of 3 back. Submitted 2/8, approved 4/18. This was the 5.56 11.5 inch. Still waiting on the AR9 and the Draco to come back. Same as the others, marked "tax exempt" and "conditional to Final Rule"

Anyone getting these back? I am at day 43 of thier current estimated 40 day wait time and have had no movement at all on my three e-form1's for the brace amnesty. No internal control numbers on my forms, nothing but crickets.

ya, they are crony'd avg 2775 with spread of 20 fps for this batch. All ammo was out of the same lot and kept in the same can so pretty darn certain nothing changed in the ammo. Temp was a bit cooler by about 20 degrees. Can't think it would put it off that far. Range today only went to 100 but...

Gonna toss this one out as I am trying to figure out what the deal is. Shot a local iron sight service rifle match yesterday and could not hit anything past 400 yards. not near misses, but with three spotters watching my lane, determined my bullets were impacting several feet low. Here are the...

Asside from wait time, my only concerns are there is no acknowlegement they got my fingerprint cards in the system. I have the tracking reciept with person's name who signed for them but other than that, no other confirmation. Since I work for a US Govt agency, I am well aware of the...

Anyone getting any back? They were at 30 days when I submitted, on day 29 for me they bumped the wait time to 40. Tomorrow is day 40 and my three still sit in the submitted folder with no internal control numbers or movement.

Haven't dumped but used Varget for the first time yesterday. Had a terrible time metering it so doubt I will use it again.

You are missing 7.62x39. I hand load hunting ammo and does just dandy on white tails here in Tennessee

I did 3 on 2/8 that are in the same boat as yours. What do ya think the hold up is? They waiting for a ruling by a judge or something?

3 form 1's submitted 2/8 Also dropped a form 4 at a FFL for supressor on 2/8 Couple notes from above. My main FFL person went to an ATF Q&A session put on by our local office. Pictures are only supposed to shot the detail of the reciever markings since these will not have to be engraved. The...