Well, I removed the firing pin and examined the firing pin bore. It was perfectly clean and free of any contamination. Went ahead and thoroughly cleaned gun and I will take to the range this weekend. If problem persists, will return for repair.
Started reloading in October 2012. I load 9mm and 45acp. Was fortunate in December to find 4lbs of Win231. I already had on hand 3lbs of Unique. An oldtimer I met at the range, who does not reload anymore, gave me an additional 4lbs of Unique. With the 7k SP and LP primers and 7k FMJ bullets...
Same problem with USPS. I ordered 4000 45acp bullets and them shipped to my office. I called the distributor and was told that they had been shipped a week earlier and their records showed them as delivered. I called the local USPS and inquired and told them that no delivery had been made. I...
All spent cases are being kicked out at about 4 yards.
With all the loads, the slide has cycled fully and consistently.
The spent brass so no signs of soot nor do the primers show any indication of gas leakage.
That is why I am at a loss of what would be the cause of this.
Went to the range to road test my new Baby Desert Eagle. After about 25 rounds, the gun failed to fire. Upon inspection, the primer had a very tiny striker dent. I loaded a fresh round and failure to fire again. This time there was no striker dent but part of the metallic primer case was...
Went to the range yesterday and was shooting 9mm reloads charged with 5.6gr unique, 115 FMJ and Remington small pistol primers. I have never had any problems with this recipe, however yesterday I noticed that my primers were extruded after firing. It looked like the primer flowed back around...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.