I have the HF dual too. So far only cleaning pistol brass.
Bought 10lbs pins on fleabay. Better to have a bit extra than not enough.
Barrels are each roughly 1/3 full with plenty of pins left over for lost pin replacement.
I do use a magnet to catch as many run away pins as I can.
6k rounds...
I'm using the dual HF tumbler. First used crushed walnut until I read about SS pins and gave it a try.
Pins work great...... easy brass rinsing and drying took a bit of experimentation.
The low bucks solution that works for me....
-small bucket and a basket with drain holes drilled in it...
few mods to my Lee progressive press
FWIW
I size st.1 and deprime at st.4 /wet SS pin tumble and walnut tumble dry /prime all st. 2 /
then change die plates, deactivate primer arm and use all 5 die stations to finish loading.
Station 1-flare/powder drop, 2-powder check, 3-drop bullet...
my reloading setup
Hi all,
Not much space in my garage for a reloading bench.
Mines compact compared to many I've seen and what I'd like but it works for the boys and I.
Now if I did it right there should be a pic of my bench below.... gimor
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.