I understand from all y'all that all S&W bbls are non-symmetrical -- i.e. they have five lands not 6, and so there's a groove directly opposite the land. And sure enough, there is. Makes measuring rather difficult. So to find the "true" size of my bore, do I just trust that the grooves are...
Here's the problem: The powders I have on hand are 231 (which I'd rather use, b/c it's open), Unique, and True Blue. So I need data that use one of these. I also have some 125 gr RN cast boolits. Until my moulds get here I must use these. Perhaps you can already see the problem. So the...
Just got my first experience with new turret (Lee Classic). I was surprised to find that the slowest part is just getting the primers seated. They tend to just barely mis-align, and require some fiddling about to get the primer in the pocket. I am accustomed to my RCBS single stage where the...
It occurred to me reading some of these threads that here is a problem I need some input on. I noticed in loading my 45's that the OAL was very slowly diminishing. Finally figured out that I was getting a buildup of the tumble lube on the post of the seating die. Turns out that the very first...
I'm trying to find a carbide taper crimp die for 9mm, and I can't remember what I did to get my 45 one. RCBS doesn''t seem to be the source, b/c their web site doesn't seem to recognize the word "die". The closest I seem to be able to come is a Lee Carbide die, but it's a factory crimp...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.