Search results for query: *

My wife just sent me this http://www.washingtonpost.com/wp-dyn/content/article/2009/02/16/AR2009021601151.html?wprss=rss_politics

Hornady's concentricity tool,check and adjust bullet run-out.Anybody test drive one of these yet?

UPS just delivered my Forster Co-Ax press and I'm anxious to get started.Been a loader for almost 40 yrs. and I'm after .002" run out or less with a full length re-size.Any input from you gents would be greatly appreciated.Thanks in advance.

Finally got around to slugging my cracked Python before sending it off to rebarrel. The slug measured .354" & .355". Thats pretty tight isn't it?

I know I'm in deep doo doo here but,I need a 6", royal blue,one pin barrel for a Python. I've tried,Colt,Brownells,Cyl. and Slide with no luck.Anybody know of one. Thanks in advance. Doug

I recently took in trade a dbl.barrel side by side 12 gauge of European origin.The only markings on it are proof markings,the serial # 12xx, and choke #182 on the underside of the barrels. Top of the barrels are marked right bbl JAMART & CO LIEGE left bbl.SPECIAL STAL. The reciever is lightly...

cracked the forcing cone on my python yesterday,anybody know a good colt man in the n/w Ohio area?

Does anybody know if Toledo Oh. passed a carry ban in the city limits?I must travel there in the wee hours of the morning with three females and feel uncomfortable going unarmed.I have a concealed carry permit.